PaintNoMore: What is DuraLast?

PaintNoMore will send a representative to measure your home or business and provide you with a free written estimate.

DuraLast Hi-Performance Coatings

DuraLast Hi-Performance Coatings is an advanced spray-on product that looks like fresh paint. However, this revolutionary coating dries up to 10 times thicker than ordinary paint to provide your home or business with long-lasting beauty you will always be proud of.

Why DuraLast Lasts So Long

DuraLast Hi-Performance Coatings’ high quality comes from its special formulation of polymers, resins, and titanium dioxide. This formulation makes DuraLast durable for decades. Unlike paint, DuraLast won’t last just a short period of time because it isn’t based on paint technology, and it doesn’t contain any fillers.

Virtually Maintenance-Free

Here’s the best part: DuraLast Hi-Performance Coatings is virtually maintenance-free — it won’t chip, peel, flake, or chalk. In addition, it resists UV rays that cause fading. The technology has been proven in manufacturing, transportation, and automotive industries where it has been used for decades because of its unique durability, flexibility, and sealing properties.

Perfect For Most Exteriors

Unlike Vinyl, It Can Be Applied to Most Paintable Surfaces:

Unfortunately, it can’t be applied to roofs or floors because it is too slippery.

How DuraLast Hi-Performance Coatings Is Applied:

Proper preparation is the key!

The homeowner’s property is respected and protected during the entire process.

Please visit our Application Process page to view pictures of these steps.

Lifetime Guarantee:

We are so convinced of the quality of our product that you will receive a transferable, lifetime residential warranty or a 25-year commercial warranty. You can turn to us with confidence.

PaintNoMore, LLC, serving Northwest Ohio and Southeast Michigan.

Any information collected by this website is confidential. It is neither shared nor sold.

free estimate contact us

— Wood

— Aluminum & Steel

— Cedar Shake Shingles

— Stucco

— Asbestos Siding

— LP Siding

— Vinyl Siding

— Cement Board

— Block & Brick

— Soffit & Fascia

— Ceilings

— Windows or Window Trim

— Columns, Posts, and Rails

— Ornate Dental Work and Other “Gingerbread”

Your Permanent Exterior Painting Solution.

Do It Once, and Be Done!

Our crews begin each job by pressure washing the surface with a degreaser and a mildewcide to clean the surface and remove any loose, peeling paint.

Next, we replace or repair all bad wood and surfaces. This step is important because a paint job will likely fail if the surfaces underneath are not prepared properly or are not in good condition. We also apply bonding agent/primer to the back side (as well as the top side) of any replaced wood to give it extra protection.

We then scrape and sand to remove any loose paint and replace any deteriorating caulk with a very high-quality sealant/caulk in the areas we are working in.

Step One: Pressure Wash

Step Two: Repair Bad Surfaces

Step Three: Scrape, Sand, & Caulk

Step Four: Bonding Agent

Next, we apply a bonding agent to the entire surface that is to receive the topcoat. It is important to apply the bonding agent to the entire surface because it prepares the surface to receive the topcoat of DuraLast Hi-Performance Coatings.

The bonding agent is a primer specially formulated to work the with DuraLast topcoat which bonds with the bonding agent and adheres firmly to it. The bonding agent also acts as an extra layer of protection against the elements.

Step Five: DuraLast Hi-Performance Exterior Coatings

Finally, the DuraLast topcoat is applied. Even though it is an extraordinarily thick liquid, it flows freely through a high pressure sprayer.

While normally sprayed on, DuraLast might be brushed or rolled on trim or in tight places.

(Click on the BBB logo for our report.)